HARD RACING PERFORMANCE
  L.L.C.   
    264 Rolling Hill Rd.  Mooresville, NC  28117  -  704-799-2192


 WEVO  Motor Mounts  for Boxster and Cayman

 

 
FRONT Semi-Solid  Engine Mount   - $129.95/each  Requires  1

The WEVO Boxster SS Racing Engine mount is designed for competition cars and offers maximum control of the drivetrain mass – without overt concessions to NVH (Noise Vibration Harshness) . This competition series mount is installed within the original Boxster (986 or 987) mount, re-using the die cast aluminum housing and flat rubber isolator flaps that straddle the mount. Unlike Solid engine or transmission mount systems, the Semi Solid installation provides sufficient isolation from engine vibrations to protect your sensitive engine control electronics and instrumentation systems.

The WEVO Boxster SS Racing Engine mount uses a 3 piece design, where a pair of aluminum hubs are completely isolated from the alloy housing by the elastomer pillow (orange part). This flexible interface between the two solidly mounted brackets - engine and chassis - is the key to managing destructive vibrations from being transferred between systems.

The Porsche O.E. Boxster mount use a combination of elastomeric and geometric features to masterfully balance the competing challenges of drivetrain location and NVH. The common failure mode (seen here) in the 986 series parts has been addressed in the 987 series parts (offered here) and the O.E. 987 mount display a more sophisticated architecture with revised geometry, plus a revision in general design and materials.

The WEVO Boxster SS Racing Engine mount and the Porsche O.E. 987 mount share an elastomeric isolation design principal. The highest level of drivetrain location desirable in competition activities, is achieved by the WEVO Boxster SS Racing Engine mount and with this comes an increase in NVH. For this reason we recommend the 987 series parts for all street, street tuner and street driven AutoX cars.


The WEVO SS Racing Boxster Engine Mount is suited for the following application(s):

Model Year(s) Application Quantity Required
986,987 1997-Present Engine Mount 1

Note: A press and selection of press tools will be necessary to remove the O.E. rubber mount prior to installation of the WEVO SS Racing Engine Mount. Installation of the WEVO SS Racing Engine Mount requires no special tools

 

 
                                                                                         (OEM 986 Mount shown for reference, not included)
REAR  Semi-Solid  Engine/Transmission Mounts   - $149.95/each   Requires 22
 

Using WEVo's proven architecture in Semi Solid (SS) mounts, Wevo has developed the Boxster SS Transimission mount as a simple and easy bolt-in replacement for the hydroelastic O.E. parts, some now 12 years old! The O.E. Boxster and Cayman transmission mounts are approaching $300 as a replacement part. The WEVO SS Boxster Transmission mounts are just over half that price and reuse the existing triangular mounting cranes on the side of your transmission.

The WEVO SS Racing Boxster Engine Mount is suited for the following application(s):

Model
Year(s)
Application
Quantity Required
986,987
1997-Present
Transmission Mounts
2

Technical Note: The M12 bolt through the Engine or Transmission mount should be tightened to 40 ft/lbs or 55 Nm. The M12 Schnorr (serrated) washer should be installed directly under the head of the M12 bolt. The M8 hardware should be tightened to 18 ft/lbs or 25 Nm using the original arrangement of washer and nut.

 


 


 

    -  CATALOG   -    CONTACT US   -    TERMS and CONDITIONS  -